My Polaris IQ 600 SHIFT 2008, carbd. When i press the reverse button it shuts off normally and then when its supposed to start up again in reverse gear it just fires once and dies. The reverse works without any problem when the sled is still a bit cold and the RPMs are a bit higher. I'm not sure if it might be idleing at too low speeds and that's why it dies when i try to use reverse. It usually works if i give a bit of gas while i press the button. I found out on the internet that it might be the piston rings that are worn out. But the sled only has 1300 miles on it so it should be all good on that part. Please help me as i am not that experienced with sleds :)
Reverse not working properly.
0 commentaires:
Enregistrer un commentaire