1994 bravo 250....no power....will barely move!

When I bought this bravo it started and idled fine but barely had enough power to move! I checked the compression and had 125, also checked all the windings on the stator.....(pulser coil - 20 ohms, charger coil - 385 which is a little low & lighting coil .3ohms)....next I swapped the carburetor ,fuel pump, secondary clutch and spark plug and even checked the airbox for blockage and still no go! Next I split the engine and found both bearings were really bad and crank seal was in rough shape too! Thinking this was the problem I rebuilt the engine with new bearings and crank seals, gaskets and piston! I also replaced all the fuel lines, cleaned up the electrical harness and connectors! After putting everything back together I had high hopes that this machine was gonna be fixed! Just a couple primes and one pull and she starts and idles really good with just a small adjustment on the carb! So I press the throttle and still the same as when I first bought it!! ? I know I had a combination of problems and fixed all of them as far as I can tell but now I'm hitting a wall of frustration with this and not sure where to turn next! Can anyone out there in the bravo skidoo world help me out with this?? Where do I go next!?
Thanks in advance!

1994 bravo 250....no power....will barely move!