Hello Everyone, I have been working on a 1980 yamaha enticer 340 and needs some help. I was not getting fuel to flow from fuel pump so I went ahead and checked all the lines including impulse line, fuel tank line and carb lines to make sure they were clear and no holes which they were. Next I ordered a fuel pump and put more gas in the tank. When I pulled the sled overy I could now see fuel running from the pump to the carb so the old pump was indeed bad. Here's where the problem starts, after a few pulls on the recoil the fuel stopped flowing from the pump to the carb. I checked all the lines and they are all still connected and the pump is new so I don't think it would go bad after a few pulls. Why would the fuel flow for a couple pulls and the stop? At this point all lines are clear,tank has fuel in it, fuel pump is new and the sled will start if I spray starting fluid into carb but stalls due to lack of fuel. Any help would be appreciated.
Help with 1980 yamaha enticer
0 commentaires:
Enregistrer un commentaire