So we finally got some snow and was able to work on the sled again. Cleaned the carbs for the 4th time. Vefied the needles are correct, clip is correct, the needle jets are correct, the cut a way is correct. The main jets are set for factory spect for my elevation and temp.320 and 310. Could not read the piolet jets but ideals fine so not two worried about that. I put in new spark plugs. Trimmed 1/4 inch on the plug wires. When the engine is cold it runs good hits the power band for about a minute or two. When engine is warmed up it just bogs down and will not move. The sound changes. Sits for a while to get cold again and will move again for about two minutes. I did the wd40 trick on the crank seal. Did not chang anything. Took the carb boots off no cracks. The crank case reeds looked good as far as I could tell. Checked the compression 110 both cylinders. I’m told that is where it should be for this fan motor.
I think I seen this problem on here before on the zr 600 and it was a stator problem. Anyone know what this stator should ome out at? How do you check the coil? Anything else I can check. Not sure where else to look. I can’t get it to run long enough to do a plug chop test.
I think I seen this problem on here before on the zr 600 and it was a stator problem. Anyone know what this stator should ome out at? How do you check the coil? Anything else I can check. Not sure where else to look. I can’t get it to run long enough to do a plug chop test.
2001 Xcf 440 help
0 commentaires:
Enregistrer un commentaire