Hello all
Out in the garage workin on the drift shaft for my 1972 -440 cheetah. I put the new drive cogs on it and when it sits on the bench the cogs don't quite line up. By that I mean when you roll it the bumps on the cogs don't hit the bench quite at the same time. Are they are offset just a few degrees on purpose? Is this done on purpose maybe to offset torque on and thru the track? Or am I missing something . I did loosen up all the bolts on both and they move a little but not enough to make them line up perfectly.
Thanks
Brad
Out in the garage workin on the drift shaft for my 1972 -440 cheetah. I put the new drive cogs on it and when it sits on the bench the cogs don't quite line up. By that I mean when you roll it the bumps on the cogs don't hit the bench quite at the same time. Are they are offset just a few degrees on purpose? Is this done on purpose maybe to offset torque on and thru the track? Or am I missing something . I did loosen up all the bolts on both and they move a little but not enough to make them line up perfectly.
Thanks
Brad
Drive cog alignment question 72-440 cheetah
0 commentaires:
Enregistrer un commentaire