1978 Moto-Ski 340E

I just picked up a 78 Moto-Ski 340E. I will admit - I know very little about sleds. I have lived in the motorcycle and automotive areas of fun/wrenching. I figured I would buy this old beast and work to get it right for my kids to taste what a Vermont winter can be like with a sled (ok and maybe for me).

The seller had it going last year (rough) he said, but lost interest in it. He rebuilt the carb and then let it set. Apparently, he drained all the oil too - then let that sit empty (odd).

I will do the typical fluids, filter, plugs, belts, electrical check/replace. He said he was going to do the points and condenser- but never did. He handed them to me in a box. So we will see - points and a condenser are outside my scope. So YouTube here I come...

Overall it is in pretty top shape cosmetically. My son (8) is all about this thing. Daughter (11) not so much yet. I?m sure she will be when the snow flies.

Any tips or tricks for this sled?

Thanks!
Josh

Also - I have seen a few spots that sell parts still, but it did not come with a service manual. That is missing item I would like to pick-up.

Attached Thumbnails

 

1978 Moto-Ski 340E

Thinking SKS

Considering moving from AC to Polaris after 18 years. Thinking I want a 2016 800 SKS 155 (ES). Can anyone confirm this is an electric start? :dunno:

Thinking SKS

Arizona Mountain snowmobiling

move from northern Michigan to Tucson Arizona looking for other Riders to ride north of Flagstaff Duck Creek area

Sent from my SM-N920V using Tapatalk

Arizona Mountain snowmobiling

1996 arctic cat zr 580 efi backfires out of the exhaust and intake

I got an 1996 arctic cat zr 580 efi. I did a top end rebuild on it and put everything back together and tryed to start it and it backfired so i replaced the stator. Then i tryed to start it and it still backfires bypassed the tss switch. But if i swap the injector timing sensor with the igntion timing sensor i will start but it will run like crap also i check the fuel injectors and one is no workng tested it and it is not getting ground :dunno: . i so confused i want to getting running by winter

1996 arctic cat zr 580 efi backfires out of the exhaust and intake

Drive cog alignment question 72-440 cheetah

Hello all
Out in the garage workin on the drift shaft for my 1972 -440 cheetah. I put the new drive cogs on it and when it sits on the bench the cogs don't quite line up. By that I mean when you roll it the bumps on the cogs don't hit the bench quite at the same time. Are they are offset just a few degrees on purpose? Is this done on purpose maybe to offset torque on and thru the track? Or am I missing something . I did loosen up all the bolts on both and they move a little but not enough to make them line up perfectly.
Thanks
Brad

Drive cog alignment question 72-440 cheetah

Looking for Edge seat jack, and have some questions!

Hey! I've been looking for a seat jack for my 2003 edge for a while now, but they must not come up to often! If anyone has one or knows of one please let me know! Also, is there more room on the '04 and '05 stock PASS seat than the regular edge seat?

Looking for Edge seat jack, and have some questions!

1999 Polaris XC 600 exhaust

Hey folks. I?m looking on the Polaris website as I need a new pipe. I found a pipe on kijiji for sale but the guy said it?s off a 2003 700 SKS 144 (which I couldn?t find on the Polaris website). Anyone know if this will work with my 99? All the 2003 700 sleds have different product numbers than the 99 (1260764).
Thanks in advance

1999 Polaris XC 600 exhaust

1998 or 1999

I just picked up my first sled, have only ridden one twice, but i wanted to get into it. I got it for $800 and it seems to run great and is pretty clean for a 20 year old machine. My question is, is it a 1998 or 1999? The registration says 1998 but when I look at pics online it looks like a 1999. Any help would be greatly appreciated, thanks.

Attached Thumbnails

 

1998 or 1999

2006 750 FST switchback

Hi,

Just wondering if anyone can give me some quick feedback. I am looking at a 2006 750 FST switchback purchase. It has 4k km's on it, and seems to be in decent shape. It needs a new rad for some reason I haven't found out why yet, but otherwise looks good.

I'm just looking for a sled to pull the kids around in the field and have some fun. No serious sledding at this point. I have seen some posts about wiring issues with this machine, outside of that they seem pretty solid and maintenance free which is what I'm looking for. This sled has a 154" track on it, which is a little long for my use but it's a good price.

Thoughts? Anything to look out for?

thx!

2006 750 FST switchback

First ride anyone??

It's snowing in the high country! There have already been a few folks that have been out in it! They must like fixing sleds ;)

Attachment 57897

It's supposed to be another AWESOME snow year! Get your sleds ready!!

Attached Thumbnails

 

First ride anyone??

Yamaha enticer 340

Will a Yamaha exciter 440 carburetor work on a Yamaha enticer 340? Just wondering if it will help wake up the old girl on it its throttle response?

Yamaha enticer 340

94 prowler 440 efi 2 up

Have a 1994 prowler 440 efi 2 up keeps flooding. Pull the plugs and turn over a few times and fires right up. Runs like it should but still floods in a few hours. Should there be voltage to the injectors with key off? I have 12.8 volts to both injectors with key off.

94 prowler 440 efi 2 up

94' Arctic Cat ZR580 - Starting Issues

Okay, i recently bought a 94' Arctic Cat ZR580 Carb from a guy a couple weeks ago. The guy told me he had it running before, but i couldnt get it to run at all. I took the carbs off and completely cleaned them. They were pretty gummed up and gross. I also found out the fuel pump was bad and replaced it with one from another sled. This sled also has new spark plugs. I checked spark from the coil and it was extremely bright and good. Spark from the plugs is good but not quite as bright as directly from the coil. Ive also made sure fuel was getting to the carbs and it is. Ive also jumpered the wires for the throttle safety switch. If i leave the sled sit for awhile i can usually get it to start after one or two pulls, but will only idle if i keep giving it throttle. If i let the sled die or kill it, i cant get it to start again unless i let it sit for a good while. (Even if the gas is left on or off) I dont have a compression checker so i cant check that but when i pull it over, it definitely feels like it has plenty of compression. I dont really know much about carbs or sleds so any help would be appreciated! I just dont understand why sometimes the sled will start but then other times it wont. Please help! Lol.

94' Arctic Cat ZR580 - Starting Issues

Seat repair help request

What would anyone suggest to put on this small spot so that it doesn't become a big spot? Will your standard automotive vinyl repair kit glue be sufficient?

Thanks.

Attached Thumbnails

   

Seat repair help request

Belvideir Il Grass drags and swap meet

Prairie Riders - Snowmobile Club Belvidere, IL

Belvideir Il Grass drags and swap meet

Pec Swap meet

Pecatonica, Il Snowmobile grass drag and swap meet
Tri-County Show Drags

Pec Swap meet

some guidance needed

im looking for a kitrle help with this sled. On most of the sites i have seen whike trying to figure this out it shows a serial number to decode. but this is the only number i can find. is there a way to decode the sked from this?

any help greatly appreciated. Cheers!

Attached Thumbnails

   

some guidance needed

Winter's coming!

After a really HOT summer, it is really exciting to see the weather report... even if it is south of me by a couple hundred miles!

First snow falls in Lake Tahoe; Kirkwood reports 3 to 4 inches | TahoeDailyTribune.com

Wyoming was supposed to get a bunch, too! Come on, SNOW!!

Winter's coming!

Polaris Rmk 700

Hi Everyone

I bought my first sled, its a 06 polaris rmk 700. Im looking for some input on the sled it self on what should I do to the motor it self cause theirs a lot of people who love it or hate it. But I do know it is the only year they made this type of motor. But besides that if there was anything else i should be looking out for?


It has a couple mods on it when I bought it, timbersled intake and a mbrp can on it as well as the whole hood covered in frogzskin venting and also a 151" track conversion

What other aftermarket parts should be a must on the 700

Thanks for the input.

Polaris Rmk 700

XLT Questions

hi i have a 96 polaris xlt high output tripple 600 do they have problims the one i have runs and rides nothing wrong with it right now please let me know

XLT Questions

old style polaris clutches

Two old style polaris closed faced clutches. Clean faces. One clutch missing spring. $100 each or $150 for both plus shipping.

old style polaris clutches

1976 Polaris TX340 free air engine package

For sale, complete engine package. Includes clutch, recoil, carbs, ignition and coil pack, fuel pump, speedo and tach. Spins freely and has good compression.
$600 plus shipping

1976 Polaris TX340 free air engine package

Hello Everyone from Colorado

Hi Everyone! Never ridden before. I picked up a 2012 RMK Pro 800 which I am hoping is a good sled for here in Colorado. From my quad/dirtbike preference, I will do a lot of trail riding but I am sure I will also climb and ride in the deep stuff so i picked a mountain sled. - Hope this is the right choice. I have some questions.

Can I use this for sled skiing with a buddy? I realize its not a 2-up but this would still be awesome for some backcountry skiing.
Whats high temp for this sled? It has scratches and I will use them on trail/hardpack.
What safety gear is needed?
Any general recommendations for know issues with this model? esp cooling - I like my engines happy....

Looking forward to the season and maybe riding with some members.
Justin

Hello Everyone from Colorado

why should I buy a Polaris ski?

I've been looking for a snowmobile for a while I came across a 800 SKS 146 what power do these have do they have problems why should I buy one

why should I buy a Polaris ski?

How much would you pay?

I'm looking into getting another sled its a 2004 polaris supersport 550. It has reverse and needs nothing, it also comes with a new belt/ cover/ plugs. It has 2700 miles and I would say good condition.What would you pay for a sled like this?

How much would you pay?

Dennis Kirk

Hey,
I really don't like going on these types of sites but these guys have annoyed me enough to do something.
I bought a windsheild for a 1975 Ski Doo Everest 440E. I bought it because their system said I was an exact fit and my fabrication skills stink. When I got the part it was nothing but disappointment, the bottom of the windshield was the wrong shape and the corners didn't line up with anything. It was like they sent the part for a different sled. Their costumer service has inorged me, tried calling and emails. So I'm going to have to pay return shipping because they are either knowingly false advertising or they don't care that they are sinding and parts. Either way I'm never buying from them again and I suggest you don't either.

Dennis Kirk

Axys seat

Hey guys. I have a 16 axys and am looking for a longer seat option for doubling the old lady now and again. Any ideas

Axys seat

97 xlt extra lite rebuild

Hello guys seem to have got myself into a bit of a Perdicument here. I'm trying to rebuild this sled and cannot find anything with it's model number.i have two problems here.
1. Torque specs
2. cant find model number

The one at hand is I have two extra #9 bolts for the crankcase that are too long. (I'm not sure how they were before as I didn't take apart) then to the problem of the model number. It's 0970756 if anyone could help send me in the right direction it would be greatly appreciated. Thank you

Attached Thumbnails

     

97 xlt extra lite rebuild

Axys seat

Hey I'm looking for a longer seat to fit my 16 axys. Anyone have and ideas out there. Hoping maybe a 2011-12 seat will fit ?

Axys seat

Kat-Kutter

What year is this? 1972? Value?

Original seat. Original carpet. Window has been replaced. Has original cover in rough shape with a few seams that came apart. Not sure why they spray bombed the right reflector area.

Attached Thumbnails

         

Kat-Kutter

Need Rear Shock Replacment

Hi guys I have a 2005 polaris supersport and I would like to replace the rear shock. What website can I go to get a replacement I can't seem to find any. Thanks

Attached Thumbnails

 

Need Rear Shock Replacment

Does anyone know what this is?

2006 FST Touring. I have no idea what this thing is. It is attached to a bracket on the rear suspension with hose clamps in a place that looks like something belongs there. I can't find anything on the parts diagrams. It is circled in red, though the circle is a bit hard to see.

Al

Attached Thumbnails

 

Does anyone know what this is?

94 Skandic II 503 - No Spark

Hi all, I have a 94 Skandic II 503 with the Ducati ignition that has finally stopped working. Over the past few years it would work fine until I shut it off then it wouldn't start again until it was cold. I replaced the CDI and it worked for a brief period and now it won't start at all- no spark. I have replaced the stator, regulator/rectifier, CDI (again, thinking that the stator could have wrecked it if was bad)... I have not replaced the trigger coil. When I removed the flywheel last, I noticed the two protrusions on the exterior were not magnetized which seems odd as they provide the signal to the trigger coil- Should they be magnetized?
Thoughts?

94 Skandic II 503 - No Spark

Hay Days!

OK it is swap meet season!

Sno Barons Snowmobile Club, Inc. - Swap_Space

Hay Days!

Bought First Sled

Hi guys just bought my first sled its a 2005 polaris 550 supersport. Its in great shape it has 2400 miles. And I think I got it for a good price. If anyone has any input good or bad let me know.

Attached Thumbnails

 

Bought First Sled

95 skidoo summit 583 hac delete, need help asap

what holes do i have to plug and how do i vent the carbs? jets and pilot jet recommend? does anyone have pictures of how to do this?

95 skidoo summit 583 hac delete, need help asap