Chain, gears needed for '78-'80 JAG 2000

My '78 JAG 2000 drive chain broke, as did one of the teeth on the small gear. Anyone have some used parts out there?

Gear 0107-651 (this is the one I really need)
Gear 0107-653 (the one I have has all of its teeth intact, but looks worn)
Chain 0107-773 (8 wide x 70 link)

Thanks for your time.
Jim

Chain, gears needed for '78-'80 JAG 2000

2003 Yamaha RX1 Leaky Carb at "T Fitting"

Hello all, I have a 2003 Yamaha RX1 which leaks fuel at the fuel intake T fitting on the right hand side (when looking at it from the front). Does anyone know a simple solution to the problem and/or the part number (or a link to a website) where I can get a the replacement part. Any help is appreciated, thanks.

Attached Thumbnails

   

2003 Yamaha RX1 Leaky Carb at "T Fitting"

1998 Ski Doo Grand Touring 700 Electrical Issues

My 98 GT 700 runs great and then will just cut out. Sometimes while it's cutting out , I'll give it some gas and will come back to life. Sometimes will run for a little while and then will go dead. Try starting, no spark. I'll wait for about an hour and starts right up. Starting to think that it's some ignition ground. THinking about buying a CDI Regulator Rectifier. I've heard when they heat up , they cut out when they're bad. Any suggestions? Seems so simple but frustrating as hell !!

1998 Ski Doo Grand Touring 700 Electrical Issues

Xcf 440 help

I have a 2001 xcf 440 sp edge I bought this summer. I thought I had it ready to go. It starts a little hard. Ideals fine runs fine when cold. It only tops out about 45 mph. Seams like it want to go faster but just can’t get there. Once it warms up it just bogs down and will not even move the sled. I have to play with the gas and once in a while I can get it going and will run in the power band for a little bit and then bogs again and will not move again. I have cleaned the carbs, new gas lines, clean the fuel screen. The main jet is 340 on both carbs. The air control is set at one turn. Ideals at 1800. Could not see the numbers on the other jet. Spark plugs are brown. Not sure where to go from here.

Xcf 440 help

SX Viper Starter Removal...How?

Hi All! I am new here, and just picked up an 02 sx viper. I am looking for instructions on how to remove the starter motor. I cannot get a tool on the bottom bolt to get it out. How do I do this?
thanks!

SX Viper Starter Removal...How?

1987 Phazer fuel line replacement

Hello thought I’d start a new thread after digging and finding to much conflicting info. First of all very new to the mechanics of anything and being my first sled I’m looking for some detailed help. Questions I have first... what size line do I need to replace fuel lines? All the same? Different? I’ve read to go directly to Yamaha and others say Tygon... but sizing def an important thing I want right, second how much line? Third is it easy to add a fuel shut off? And lastly if you could try and give a newbie detailed instructions on how to tackle this I’d appreciate it. Steps? Does my gas tank need to be removed and if so how? I’m headed to siphon the tank.

1987 Phazer fuel line replacement

bogging 600 cleanfire

hey guy..newbie on here, I have a 2009 dragon 600 sp that bogs at half throttle, stator was verified at dealership..i cleaned exhaust valves, replaced bellows any thoughts?? This is my first non carbed sled...I have to say..im not really happy with it so far..plz help

bogging 600 cleanfire